Take appropriate amount of water and splash it on the face to moisten the face, take appropriate amount of facial cleanser (usually 3 to 5 cm) on the palm of your hand, add water and rub until foamy, apply to the face and massage for one minute, rinse with clean water.
When using, wet your face first, then on the forehead, nose tip, cheeks, and then squeeze an appropriate amount of facial cleanser on your hands, gently rub it, and then massage your face in circles from bottom to top and from inside to outside for a few minutes. Pay attention to cleaning the T-zone and U-zone, which are easy to hide dirt, and then rub it with clean water, gently massage for half a minute, and then wash it off.
Specific steps
Step 1: Wet your face with warm water
The water temperature for washing your face is very important. Some people save trouble and wash their faces directly with cold water; some people think that they have oily skin and need very hot water to wash the oil on their faces. In fact, these are all wrong views. The correct way is to use warm water. This can ensure that the pores are fully open without excessively losing the skin's natural moisturizing oil.
Step 2: Make the cleanser foam fully
No matter what kind of cleanser you use, the amount should not be too much, the area is the size of a coin. Before applying it to your face, you must first make the cleanser foam fully in the palm of your hand. Most people forget this step, and this step is also the most important step. Because if the cleanser does not foam fully, it will not only fail to achieve the cleaning effect, but also remain in the pores and cause acne. Of course, the more foam the better, and you can also use some tools that make the cleanser foam easily.
Step 3: Gently massage 15 times
After applying the foam on your face, massage gently in circles, don't use too much force to avoid wrinkles. Massage about 15 times to let the foam spread all over the face.
Step 4: Wash the cleanser
After massaging with the cleanser, you can wash it. Some women are afraid that they can't wash it clean, so they scrub it hard with a towel, which is very bad for delicate skin. You should use a wet towel to gently press on your face, and after repeating it several times, you can remove the cleanser without hurting the skin.
Step 5: Check the hairline
After washing, you may think that the face washing process is complete, but it is not. You should also look in the mirror to check if there is any residual cleanser around the hairline. This step is often ignored. Some women are prone to acne around their hairline because they ignore this step.
Step 6: Wash with cold water 20 times
Finally, use both hands to wash the face with cold water for about 20 times, and gently apply a towel dipped in cold water to the face. This can tighten the pores and promote blood circulation in the face. This is the end of the whole process of washing the face.
How to use facial cleanser
Dec 20, 2024
Leave a message
